Chemtools GalMax NPR Silver Galvanising Paint 400G

Chemtools GalMax™ SG Silver 3-in-1 Galvanising Paint 400g Aerosol CT-SG-400 GalMax™ SG Silver 3-in-1 Galvanising Paint gives exceptional premium protection against rust and corrosion, and weathers to the same colour as normal galvanising. It is fast drying and ideally suited to touch-up welds and damaged structures or components. SG Silver can also be used extensively in the maintenance and restoration of damaged or worn galvanised metal, and when used in combination with GalMax™ 90 Cold Galvanising Paint will offer long-term corrosion protection of steel and iron structures or equipment. Excellent weathering caracteristics GalMax™ SG is supplied to a wide range of industries, from marine to construction. It is commonly used on marine and offshore rigs, during metal fabrication, for hot-dip gal repairs, and to rust proof bridges, cooling towers, fencing and piping, and metal roofing. Ideally suited for touch-up and rust-proofing welds, hot dip galv repairs, and damaged steel components Can be used as a primer to seal out moisture on all metallic surfaces, with excellent adhesion to most metals. ***IMPROVED formula with extra fine zinc particles means no blocked nozzles*** Ensure the surface is clean, dry, and free of contaminants, removing all scale and rust as far as possible before application. Do not use acidic rust converters or removers. Do not paint over loose or unsound surfaces. Drying times are temperature dependent. Invert the can and shake well for at least one minute. Shake often during use. Hold the can upright and angle the fan jet for a horizontal or vertical pattern. Apply in even sweeping strokes approximately 250mm to 300mm from the surface. Apply several light coats a few minutes apart rather than one heavy coat. After spraying, invert the can and press the nozzle to clear the jet. If blocked, use fuse wire and mineral turps to clean the nozzle. Do not paint at temperatures below 15oC or above 40oC. Avoid high humidity Specifications Colour Gloss Silver Zinc in Dry Film 10% Aluminium Rich Yes Recommended Film Thickness 40µm (1.6 thou) VOC Content 50% Heat Resistance Up to 100oC Application Conditions Temperature 15oC to 40oC Humidity 85% RH Max Drying and Coating Touch Dry* Approx. 10 minutes Re-Coat/Top Coat* Approx. 2 hours Top Coat Required No Re-Coat with Water-Based Paints Yes Re-Coat with Solvent-Based Paints Yes Coverage Aerosol 2.55m2 per 400g can Compatibility/Suitability Iron - Steel - Wrought Iron - Galvanised Steel - Duragal® -Zincalume® -Colourbond®- Aluminium -Copper Not Compatible Stainless Steel.