CEA Shark25 Plasma SK25 Replacement Plasma Torch 4mtr Direct Connect

CEA Shark Plasma 35 Replacement Torch SK25. (Hard Wired) SK torches are dedicated to manual cutting, while SKM are designed for automatic cutting. The SK (mounted on single-phase systems) are based on the "Back Striking" system, on the contrary the SK and SKM (used on three-phase systems) are characterized by HPC (High Performance Cutting) technology which allows the generation of radial gas flows. BACK STRIKING TECHNOLOGY It represents the best solution for plasma torches up to 60 A. In conventional torches without high frequency, the arc striking is obtained by means of compressed air which moves away the electrode head from the inner part of the nozzle. This system causes, in the plasma flow exit area, both electrode and nozzle material deterioration because of burns and deformations subsequent to pilot arc striking between them. In contrast, the back striking system takes place in the rear side of the electrode and nozzle, thus leaving clean and unaltered the flow exit area. Main advantages are: Longer life of the consumables Striking always precise and safe Better cutting quality over time Main features high cutting speed optimal quality and cleanliness of the cut surfaces high concentration of the plasma cutting beam lack of dross reduction in the heat affected zone longer life of the consumables piercing on lamination achieved in shorter times All SK torches are fitted with a coaxial cable which combines great flexibility to robustness and resistance to crushing.